How does the Crystal Panel work? A thin plexiglass is engraved according to a special, dedicated algorithm in a point or linear pattern. A LED light is entered into the Light Guide Panel, which spreads evenly over the entire surface by scattering on the engraving. In this way, a flat panel is professionally protected against light leakage, overheating and differences in lighting.
*optional thicknesses are possible: 8mm, 10mm and larger
* optionally, 3 edges can be illuminated on request
* optional 5V
The Light Guide Panel can not be exposed to direct contact with water. Indoor use is recommended. In other cases it is required to provide ventilation and rapid removal of steam and moisture from the casing/ cassette in which the Light Guide Panel is mounted.
This site uses cookies. By browsing the site you accept the privacy policy and the GDPR. more information Accept
The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.
Close